HotRod Dec. 2014 Issue

 

 

 

 

 

 

 

 

 

 

 

 

412.881.1000

 

 

RCS Performance Engineering

For Sale $20,000

Super Bad 84 SS Monte Carlo

84 SS Monte Carlo

84 SS Monte Carlo

84 SS Monte Carlo

84 SS Monte Carlo

84 SS Monte Carlo

84 SS Monte Carlo

84 SS Monte Carlo

1984 Chevy SS Monte Carlo Classic/Hotrod
Professionally redone by RCS/ Race Car Service of America
Odometer - 52,000
New Pa Inspection
Outside Color – 1997 Indigo Dark Blue
Inside Color– OEM Medium Blue OEM SS Cloth Fabric
Engine – Custom 450Hp 355” (see details on engine information)
Trany – Perf 350HT with shift kit and a TCI 3,000 stall speed converter
Rear Axle –Buick GN all new 3.42 Posi 8.25 Clutch Pack Carrier with new 28 spline axles
Exhaust – Dual, Hooker Header, 3” Mandrel bent pipes with Flow Master 40 Series Mufflers.
Wheels and Tires – Steel Chrome wheels, 7” wide in the front and 8” in the rear, Firestone Tires

This car is kept in a heated garage and has not seen rain or even a water hose since it was built some 15 years ago it's always covered. The car is only driven once in a while and doesn’t have 1,500 miles on it since it was put together. Why? I have a few other vehicles that also stir my interest and cars like these you don’t drive everyday anyway. So you enjoy them when you feel the time is right. This is a great car, good looker and has a great engine sound like no other. It has great power, runs on 91 to 93 Octane fuels and never needs any adjustments. It runs and drives great, and is a head turner for sure. Great cruiser fun to drive, built by RCS a professional shop in Pittsburgh, well taken care of toy. It’s a great street performance car that will turn some heads! This car is not all raced up with accessory parts that cheapen the OEM look, it is tastefully updated.

Built by- RCS and Engine Dyno Tested
Power out put- Dyno tested at 480Hp with an open plenum intake manifold and 450Hp with a dual plane manifold, all else the same.
Block- 010-350 S/B Chevy studded 4 bolt Main
Crank- GM Steel 3.480 Stroke
Rods- Crower Sportsman 4340 Steel full floating
Pistons- JE Racing Pistons, Flat Top, Ceramic coated tops and Moly coated skirts.
Wrist Pins- Taper Wall
Cylinder Heads- Steel GM Chevy Bowtie with angle spark plugs, 2.020/1.600 valves with 67cc chamber, screw in studs and push rod guide plates.
Valves- Manley Stainless +.100
Valve Springs- Crane Dual
Retainers- Crane Steel Moly 10 degree
Push Rods- Crane 5/16 x +.100 Harden Chromalloy
Intake Manifold- Edelbrock RPM Performer
Carburetor- Holley 4150- 750 CFM Dual feed double pump
Fuel Pump and lines- Holley mechanical with steel braided lines
Piston Rings- Speed Pro Moly 1/16 compression rings
Mains and Rod Brgs- Speed Pro Race
Oil Pump- Melling High Volume
Oil Pan- Moroso 8qts
Timing Chain- Cloyes True Roller
Camshaft- Ultradyne Mechanical Flat tappet- 255-263 -106F .585 Gross Lift
Rockers- Crane Roller 1.5 ratio
Stud Girdle- CompCam
Valve Covers- Tall Dual breathers Die Cast Aluminum
Distributor- Accel Performance and Coil
MSD 8.5mm Ignition Wires
Interior
New Head Liner
New Rug
New SS Monte Carlo floor mates
Newly refabricated front seats with OEM SS original factory material.